IConfig 4.2.0 mfc issues with Protools 12.5
Hello to all
Today i have installed the newer iConfig V4.2.0
This has also installed and mfc from the MS c+ redistributble package (somthing qith mfc100u or similary).
After that it was not possible to load Protools 12.5 due to an error message about this mfc.dll
So i have installed an older mfc redistributal from 2013 and Protools works.
Of course if this fallback the iconfig Tool could not be loaded due to an error message.
So i suggest that iConnect hecks for this mfc incompatiblity with Protools 12 under Windows.
Today i have installed the newer iConfig V4.2.0
This has also installed and mfc from the MS c+ redistributble package (somthing qith mfc100u or similary).
After that it was not possible to load Protools 12.5 due to an error message about this mfc.dll
So i have installed an older mfc redistributal from 2013 and Protools works.
Of course if this fallback the iconfig Tool could not be loaded due to an error message.
So i suggest that iConnect hecks for this mfc incompatiblity with Protools 12 under Windows.
Comments
http://duc.avid.com/showthread.php?t=379893
Now if there were a similar fix that could get the Mac PT10 drop-down menus to draw without dragging the mouse over them in OS X 10.10 and later, I'd be really happy.
This has been annoying me for a couple of years. I was actually thinking about setting up a system drive with 10.9 and just putting PT 10 on it.
Fantastic. I'm excited.