Auracle for X-Series mioXM

lee · June 2021

Hi, Is it possible to rename DIN Source and Destinations differently in Auracle? When I name the source, e.g. for DIN3 to 'Jupiter X' the destination gets the same name, and when I rename the destination the source also take that name. I want to label them according to the device they are connecting to /originating from. Thanks.

tsho08 · June 2021

Not currently possible. I've requested to see what options we could have for this in Auracle X.

lee · June 2021

OK, thank you.

TheWhistler · July 2022

I second that. It would be way more intuitive if one could name the outs - outs and the ins - ins.
The Mio is complex device and every bit of orientation is highly appreciated.

tsho08 · July 2022

I'll pose this question back at everyone in this thread to get some feedback on how this could be best implemented.
I've been thinking about this. Here's the biggest hurdle.
- Our interfaces show 16 MIDI ports that are in and out on the computer. The name covers both in and out for that port. How do we get a DAW to see it differently?

Image: https://forums.iconnectivity.com/uploads/editor/e4/wpvj1i9w8yx0.png

If you create new hardware devices and connect them to ports in MIDI Studio (Mac) you can get the correct in and out names to show up in Logic only.

Image: https://forums.iconnectivity.com/uploads/editor/ha/vu97jxcfu27y.png

Image: https://forums.iconnectivity.com/uploads/editor/x2/9saecb449j5t.png

Other DAWs don't show it.

Auracle for X-Series mioXM

Comments